Real-Time Visibility Into Your Building’s Energy
We design and install custom energy monitoring systems that tell you exactly what your building consumes, when it consumes it, and where the waste is — so you can act on facts, not estimates.
Residential energy end-use breakdown — Natural Resources Canada
Most energy waste is invisible — until you measure it
Space heating alone accounts for 63.6% of a typical Canadian home’s energy use. In commercial and institutional buildings the picture is similar — yet most operators make efficiency decisions without any direct measurement of what their systems are actually consuming.
An energy monitoring system changes that. It gives you a continuous, granular record of consumption across every fuel source and subsystem — so inefficiencies show up in a dashboard, not in a year-end utility bill.
What We Measure
Every system that moves energy through your building can be instrumented, logged, and reported.
⚡
Electrical Systems
- Whole-building consumption & peak demand
- Sub-metered panels and circuits
- Power factor and reactive power
- Lighting, plug loads, mechanical equipment
🔥
Thermal Energy
- Boiler and furnace output (BTU/h)
- Supply & return temperatures, flow rates
- Heat pump performance (COP)
- District energy and thermal metering
💨
Indoor Environment
- Zone temperatures and humidity
- CO₂ concentration by area
- Correlation with occupancy schedules
- Ventilation and fresh-air performance
From Specification to Live Data
We handle the entire process so your team doesn’t have to.
1
Assess & Design
We audit your facility, identify metering points, and specify sensors, data loggers, and communication architecture suited to your systems and goals. You receive a complete design package before any hardware is ordered.
2
Install & Commission
Our team handles procurement, mounting, wiring, and commissioning — coordinating with your electrical contractor and BAS vendor. Installation is documented and code-compliant, with full handover notes for your facilities team.
3
Monitor & Report
Data flows continuously to your dashboard. Automated interval reports, anomaly alerts, and trend analysis give you and your team the information needed to act — without manually checking anything.
What Your Dashboard Looks Like
● LIVE DATA — Updates every 15 min
Monthly Consumption
45,230 kWh
↓ 12% vs last month
Peak Demand
248 kW
Tuesday 2:15 pm
Heating Output
187k BTU/h
⚠ 18% above setpoint
Avg CO₂ — Zone 3
650 ppm
✓ Within target range
Illustrative example — actual dashboard configured to your systems and reporting interval
What Monitoring Enables
📋
Measurement & Verification
Produce auditable before-and-after data to confirm energy savings from retrofits — required for most utility incentive and grant programs in Alberta.
🔍
Fault Detection
Catch equipment faults, scheduling errors, and abnormal consumption patterns automatically — before they compound into expensive failures or comfort complaints.
📈
Capital Planning
Rank retrofit opportunities by measured energy impact rather than estimates. Prioritise investments that deliver the highest return with data-backed confidence.
🏛️
Baseline & Reporting
Establish a calibrated energy use baseline for budgeting, benchmarking against comparable facilities, and satisfying reporting requirements for incentive programs.
Ready to Start Measuring?
Tell us about your building and what you need to know. We’ll scope the right system for your facility.